Infrasonic Product Categories at infra-sonic.com

Uncolored Frequency Reproduction. Analog Input.
Adjustments for Room Acoustics. 90-Watts of Mind Blowing Audio.

BLOW5 is a 90-Watt, powered near-field studio monitor speaker. BLOW5 features a two-way, bi-amplifier design to achieve high quality sound. Frequency response is broadened downward by a bass reflex system, and broadened upward by a natural silk dome tweeter for delicate signal reproduction. Enclosure design contributes to the broad frequency response.

From the commercial studio to the home studio, BLOW5 is the premier solution for near field studio monitoring in its class. Use the controls on the back panel of the BLOW5 to your control room acoustics. With output this accurate, you'll hear what you've been missing.

Features

Units per Package

One pair (two speakrs)

Blow 5

2-way bass-reflex bi-amplified 5 inch near field studio monitor
Flat frequency response (짹1.5 dB, 58 Hz to 20 kHz) and wide passband frequency (50Hz ~ 22kHz)
90 watt (40 watt HF and 50 watt LF) Full discrete power amplifiers with servo-loop and perfect protections.
0.75" natural silk dome High frequency transducer
5.25" Polymer coated paper fiber cone low frequency transducer
Full magnetic shielded enclosure and independent amplifier room
XLR and 1/4"TRS phone jack balanced/unbalanced inputs
EASC (Enhanced Acoustic System Compensation) Technology
Input sensitivity control
High frequency 3-step tilt controls switch
Acoustic space control switch
Bass cut-off frequency control switch
5th order active crossover network
Front Illuminant Logo lamp and protection indicator
High-strength cabinet constructed MDF composite with radius edges

Multimedia

Click the image below to view the Flash Introduction to this product in a new window.

Size: 791Kb
Player will open in a new window and may be resized.

Images

Blow5 Reference Monitor. Click to enlarge.

Blow5

Specifications

System / Enclosure

Two-way, bi-amplified reference monitor (bass-reflex type)
Free field frequency Response: 58Hz ~ 20kHz (+/- 1.5 dB)
Free field cutoff response 50Hz ~ 22kHz (+/- 3.0dB)
Enclosure Resonant Frequency (vent tuning): 62Hz
Measured Maximum Continuous: 105dB SPL / 1m
Harmonic distortion at 90 dB SPL @ 1 m on axis: 0.5% under
Low frequency driver:
    - Diaphragm Type: Polymer coated paper fiber cone type
    - Diameter: 5-1/4" (133 mm)
    - Voice Coil: 1.0" (25 mm)
    - Magnet Type: Ferrite magnet with magnetically shielded
    - Impedance: 8 ohms
High Frequency Driver
    - Diaphragm Type: Natural Silk Dome with Waveguide.
    - Diameter: 0.75" (19mm) diaphragm
    - Magnet Type: Ferrite magnet with magnetically shielded
    - Impedance: 8 ohms
Low Frequency Vent Type : Front ported, Slotted aperture
Internal cabinet volume: 7.2 liters
Enclosure Construction: 15mm (5/8 ) Vinyl-laminated M.D.F
Dimensions : (190 mmW x 300 mmH x 266 mmD)
Weight : 6.5 kg

Amplifier / Crossover

Power amplifier topology:
    - Class A-B Full discrete power device amplifier with Servo-loop
    - DC, Over-load and Over-current protection
    - Supply monitoring protection with Mute control
Output power rating:
- 50watts (<0.1% THD into 8 ohm)
- 40watts (<0.1% THD into 8 ohm)
Total Harmonic distortion + Noise: < 0.01% (@ 1 kHz, 100dB SPL)
Signal-to-noise ratio: > 106dB
Slew rate : >15V/us
Input sensitivity control range (@output power 60W, trim):
+22dBu at control min
-9dBu at control max
Connector: XLR input, 1/4" TRS Balanced input (impedance 20kOhm)
Crossover: 3.0 kHz, 30dB/otc 5th order active filter
High frequency tilt control : -2dB / Flat / +2dB (@ 10kHz)
Room control : Flat / -2dB / -4dB (@ 100Hz)
Base cut-off frequency control : Flat / 80Hz(THX) / 100Hz (-12dB/octave)
Acoustic System Compensation rage : 30Hz ~ 200Hz, +/-6dB Max
Indicator: power/protection (front, white LED)
AC Power Input :
- Max rated power : 115 watts
- 100 ~ 120VAC, 200 ~ 240VAC, 50~60Hz via IEC power INLET

DA-912

Not installed in BLOW5. See BLOW5D.

INFRASONIC, WINDY6, BLOW5, BLOW5D, BLOW4, BLOW4D, INFRASONIC DeuX, INFRASONIC AMON, INFRASONIC Quartet, JamMate and SIMS Audio are trademarks of SIMS Corporation. All other trademarks remain the property of their respective owners.



Copyright © 2024, SIMS Corp. All Rights Reserved / Mail: tech1@simsaudio.com Privacy Policy \| Terms & Conditions \| Other Sites : SIMS \| JamMate \| Clive [Admin]