|
|
Welcome to INFRASONIC website.
|
BLOW5D Studio Monitor
|
Products > Reference Monitors > Blow 5D
|
|
|
 |
|
Uncolored Frequency
Reproduction. Digital and Analog
Input.
Adjustments for Room Acoustics. 90-Watts
of Mind Blowing Audio.
BLOW5D is a 90-Watt, powered near-field
studio monitor speaker. BLOW5D features a two-way, bi-amplifier
design to achieve high quality sound. Frequency
response is broadened downward by a bass reflex
system, and broadened upward by a natural silk
dome tweeter for delicate signal reproduction.
Enclosure design contributes to the broad
frequency response.
BLOW5D is equipped
with a DA-912 digital interface
module, enabling BLOW5D to be connected to
various digital inputs such as AEU/EBU(XLR),
S/PDIF(RCA) and an RCA thru connector. The D/A
converter in DA-912 supports up to an amazing 24-bit/192kHz sample
format with 123dB dynamic range.
From the commercial studio to the home studio, BLOW5D is the premier
solution for near field studio monitoring in its
class. Use the controls on the back panel of the BLOW5D to your control
room acoustics. With output this accurate, you'll
hear what you've been missing.
Features
Units per Package
Blow 5
- 2-way bass-reflex bi-amplified 5 inch near
field studio monitor
- Flat frequency response (±1.5 dB, 58 Hz to
20 kHz) and wide pass-band
frequency (50Hz ~
22kHz)
- 90 watt (40 watt HF and 50 watt LF) Full
discrete power amplifiers with
servo-loop and
perfect protections.
- 0.75" natural silk dome High frequency
transducer
- 5.25" Polymer coated paper fiber cone low
frequency transducer
- Full magnetic shielded enclosure and
independent amplifier room
- XLR and 1/4"TRS phone jack
balanced/unbalanced inputs
- EASC (Enhanced Acoustic System Compensation)
Technology
- Input sensitivity control
- High frequency 3-step tilt controls
switch
- Acoustic space control switch
- Bass cut-off frequency control switch
- 5th order active crossover network
- Front Illuminant Logo lamp and protection
indicator
- High-strength cabinet constructed MDF
composite with radius edges
- DA-912 Digital interface module
- XLR for AES/EBU (IEC60958) and RCA for
S/PDIF coaxial digital inputs
- RCA thru out port for stereo connection
- IEC60958 EIAJ CP1201 compatible 24-bit
digital input with up to
192kHz
sample-rate
- High-end 24-bit/192kHz D/A converter with
123dB dynamic range
- XLR/RCA source and Left/Right channel
selection switch
DA-912 Digital Interface Module
- XLR for AES/EBU (IEC60958) and RCA for
S/PDIF coaxial digital inputs
- RCA thru out port for stereo connection
- IEC60958 EIAJ CP1201 compatible 24-bit
digital input with up to 192kHz
sample-rate
- High-end 24-bit/192kHz D/A converter with
123dB dynamic
- XLR/RCA source and Left/Right channel
selection switch
Multimedia
Flash Introduction (above). Size: 791Kb.
Above player will open in a new window
and may be resized.
Images



Specifications
System / Enclosure |
- Two-way, bi-amplified reference monitor
(bass-reflex type)
- Free field frequency Response: 58Hz ~ 20kHz
(+/- 1.5 dB)
- Free field cutoff response 50Hz ~ 22kHz (+/-
3.0dB)
- Enclosure Resonant Frequency (vent tuning):
62Hz
- Measured Maximum Continuous: 105dB SPL / 1m
- Harmonic distortion at 90 dB SPL @ 1 m on
axis: 0.5% under
- Low frequency driver:
- Diaphragm Type:
Polymer coated paper fiber cone
type
- Diameter:
5-1/4" (133 mm)
-
Voice Coil: 1.0" (25 mm)
- Magnet Type:
Ferrite magnet with magnetically
shielded
- Impedance:
8 ohms
- High Frequency Driver
- Diaphragm Type:
Natural Silk Dome with
Waveguide.
-
Diameter: 0.75" (19mm)
diaphragm
- Magnet
Type: Ferrite magnet with magnetically
shielded
- Impedance:
8 ohms
- Low Frequency Vent Type : Front ported,
Slotted aperture
- Internal cabinet volume: 7.2 liters
- Enclosure Construction: 15mm (5/8 )
Vinyl-laminated M.D.F
- Dimensions : (190 mmW x 300 mmH x 266 mmD)
- Weight : 6.5 kg
|
Amplifier /
Crossover |
- Power amplifier topology:
- Class A-B Full
discrete power device amplifier with Servo-loop
- DC, Over-load and
Over-current
protection
- Supply
monitoring protection with Mute control
- Output power rating:
- 50watts (<0.1%
THD into 8 ohm)
-
40watts (<0.1% THD into 8 ohm)
- Total Harmonic distortion + Noise: <
0.01% (@ 1 kHz, 100dB SPL)
- Signal-to-noise ratio: > 106dB
- Slew rate : >15V/us
- Input sensitivity control range (@output
power 60W, trim):
+22dBu at control
min
-9dBu at control
max
- Connector: XLR input, 1/4" TRS Balanced
input (impedance 20kOhm)
- Crossover: 3.0 kHz, 30dB/otc 5th order
active filter
- High frequency tilt control : -2dB / Flat /
+2dB (@ 10kHz)
- Room control : Flat / -2dB / -4dB (@ 100Hz)
- Base cut-off frequency control : Flat /
80Hz(THX) / 100Hz (-12dB/octave)
- Acoustic System Compensation rage : 30Hz ~
200Hz, +/-6dB Max
- Indicator: power/protection (front, white
LED)
- AC Power Input :
- Max rated power :
115 watts
- 100 ~
120VAC, 200 ~ 240VAC, 50~60Hz via IEC power
INLET
|
DA-912 |
- Connector: XLR input (AES/EBU, IEC60958),
RCA input (S/PDIF, EIAJ CP1201), RCA thru output
- Sample Rates: 192kHz, 176.4kHz, 96k Hz, 88.2
kHz, 48 kHz, 44.1 kHz, 32 kHz.
- Tolerance: +/- 3%
- Word Length: 16-24 Bit
- Digital Analog Converter: 24-bit/192kHz
Multi-bit delta-sigma with 8xdigital filter
- Total Harmonic distortion + Noise : 0.0005%
(@1kHz, -3dBFS)
- Dynamic range : 123dB A-weighted, (@1kHz,
-60dBFS)
- User interface : Input source selector
(AES/EBU/Coaxial), Channel selection
(Left/Right),
- Statu indicator LED
|
INFRASONIC,
WINDY6, BLOW5, BLOW5D, BLOW4,
BLOW4D, INFRASONIC DeuX, INFRASONIC AMON,
INFRASONIC Quartet,
JamMate and SIMS Audio
are trademarks of SIMS Corporation. All other
trademarks remain the property of their respective
owners.
|
|
|
|
|
|
|